If you over tighten the screws that hold the front binding post to
the frame you may push the nylon spacers into the frame and
short out the circuit. These spacers are the ones that are referred
to as insulating pieces in the section about removing the
binding post.
Machine assembly help..
feel free to drop us a line [email protected]
-
Capacitor and voltage
, Uncategorized, capacitor, tune, tuning, voltage, 0
To compensate for a higher rated capacitor you might have to add voltage to your machine to get the...
-
Wear Gloves when applying stencils
, Uncategorized, application, gloves, stnecil, tattoo, 0
Gloves should be worn during all times of stencil application, and the skin should always be cleaned prior to...
-
Most effective way to sterilize surfaces and gear?
, Uncategorized, chemicals, cleaning, gear, sterilization, 0
Sanitation chemicals come from all different suppliers and manufacturers. These chemicals are typically not usable on instruments that will...
-
Power supply selection..
, Uncategorized, gear, power, purchase, supply, 2
Tattoo power supplies, like everything else in tattoo, are a matter of personal preference. The artist will have to...
-
Traditional Liner
, Uncategorized, liner, machine, tuning, 0
The traditional liner setup, in my opinion, is a machine that runs really fast, hits hard, and has a...
-
Stencil Materials Used
, Uncategorized, design, layout, planning, stencil, tattoo concept, 0
7.1 Stencil Materials Used The stencil application process can cause a lot of new tattoo artists some grief, but...
-
More or Less Needles?
, Uncategorized, lining, needle, resistance, rules of thumb, 0
A good rule of thumb is that the more needles you have (up to a certain point), the easier...
-
Tattoo Machine Troubleshooting
, Uncategorized, tattoo gaps, tattoo machine, tattoo machine troubleshooting, tattoo power cord broken, tuning tattoo machine, 2
If you’re having problems with your clip cord and you don’t know what it is, it just doesn't seem...
Recent Comments