sel1974tattoo

As mentioned earlier the front spring length can be changed to
achieve different results in the tuning of the tattoo machine. The
rule of thumb here is that the shorter the front spring, the stiffer
it will be.

The rear spring on a standard tattoo machine has to be bent
(according to most tattoo artists), at least to some degree. This
is considered a major flaw in the age old design of the armature
bar. It is because the

Similar to the dime gap technique, the manila envelope is another
measurement that has some debate surrounding it. Some artists
will tell you that when you put the a-bar in the stressed position
you should be able

Often times you will hear an artist talk about the importance of
the dime gap. There is some debate as to which way the dime
gap is measured, and if you should even use a dime at all.
There are two basics ways

Triangle (ABC)
starts with point (A) being where the contact point touches the
front spring. Triangle (ABC) continues with point (B) being where
the rear spring is fastened to the deck. Triangle (ABC)’s last
point

There are two springs on the standard tattoo machine, the front
and the rear. In the standard spring setup the rear spring is basi-
cally rectangular, while the front is triangular. Springs will

The ghost of the a-bar is based upon a few things: the human
eye’s interpretation of the reflection of the light off of the a-bar,
the speed of the a-bar, and the actual light source that you have
in the room.

When speaking of how hard a
machine runs we are generally
speaking about the hit of the
machine. When we are talking
about how fast or slow a
machine runs we are referring
to the momentum of the machine.
The hit

Remember you have a host of aftermarket parts available to
you, and you do not have to keep the manufacturer’s parts on
the frame. Sometimes you can increase the performance of the
machine by swapping out just a

Have your machine hooked up to a power supply while you are
putting the a-bar assembly back on the machine – this will help
you to properly tune it before you tighten everything down.

If you over tighten the screws that hold the front binding post to
the frame you may push the nylon spacers into the frame and
short out the circuit. These spacers are the ones that are referred
to as insulating

The first thing a new apprentice should do upon getting their first
tattoo machine is to take it apart. It is very important for a tattoo
artist to know exactly how the entire machine works, and how
it is

Like everything else on the tattoo machine, experiment and
play around to find out what works best for your style and your
specific machine. Some artists will claim that a certain metal
will increase the machine’s

Some artists will purchase contact points with a design on the
top. You may have seen this design as a dice, skull, or almost
anything that is imaginable. Do not be fooled by the clever
novelty of the contact

The contact point can be made of different metals. One would
assume that the best quality metal would be the most conduc-
tive. Typical contact point metals are brass, copper, and silver.
If corrosion occurs, or

Typically the contact point will be at a 90 degree angle in relation
to the front spring. This will ensure that there is optimal
surface area between them, and provide for good conductive
contact. The contact

The contact point is another important part of the tattoo machine.
The contact point is the tiny actual spot on the machine
where the magic happens. Electricity flows through the machine
and ends up in the contact

There is more often than not, an o-ring looped around the front
spring. This will aid in the transition of energy created by the
front spring hitting the contact screw. Different thickness o-rings
should be

Armature bars can come in a multitude of shapes and sizes as
well. Some will have notches or holes drilled in them while others
might resemble the shape of the number 8. These shapes
and designs are to modify the

The prime component, as far as movement is concerned, in the
tattoo machine is the armature bar. The armature bar has two
functions. The first function is to attach the needle to the machine.
The armature bar’s